Download Print this page

Table Of Contents - Uni-P Dry H20 200C Installation, Operation & Service Instructions

Advertisement

Uni-P H20 200C DEHUMIDIFIER
Important Notes
How it Works
Installation Requirements
Key Functions
Indicator Lights
Operating Instructions
Unit Diagram
Dehumdifier Storage
Ducted Applications
Troubleshooting
Warranty Information
Tel: 888-990-7469
Installation, Operation & Service Instructions
2
2
3
3
3
4
4
6
7
8
9
9
12
12
13
14
15
Uni-P H20 200C DEHUMIDIFIER
1.Important Introduce
The Unip H20 200C is a split system dehumidifier with sensible cooling
that is integrated into the heating and cooling system to provide the
ultimate in comfort, health and property protection through:
• Dehumidification
• Sensible Cooling
• Fresh Air Ventilation (Optional)
• Air Filtration
The two-piece design allows the sensible heat load generated from
dehumidifying the house to be released in the outside condensing unit,
thus eliminating additional cooling and reducing air conditioner run time.
2.Features
It is made with a low voltage control system.
It has the R410A refrigerant, which is generally environmentally friendly.
It features an auto-restarting operational system after power outages.
It used the standard MERV-11, which offers superior air filtration.
The device has a quiet operation.
It is designed with a long life and high-efficiency impeller.
It has an optimized and perfectly patented air-to-air heat exchanger.
The device brags of industry-leading effectuality.
4,300 BTU cooling.
3.Safety Notes
This type of dehumidifier is designed in such a way that it is suitable for indoor installation
in a room that is perfectly protected from flooding and rain.
The condensing unit must always be protected from elements such as snow, rain, and
sunlight although the device can be installed outdoors.
Ensure that the discharge air is not directed at people, or over water in spa and pool areas.
Install dehumidifier according to all applicable local
If the device is meant for use near water, spa or a pool, make sure that there are no possible
chances of the unit being splashed or/and falling into the water. Also, make sure that it is plugged
into an outlet that is protected by the GFI (Ground Fault Interrupt) circuit.
Always connect your dehumidifier using a grounded, dedicated electrical connection that is
GFCI protected with at least 15 amp capacity.
The use of any other type of wiring will void your warranty.
1
Installation, Operation & Service Instructions
,
,
state
and national codes.
Tel: 888-990-7469

Advertisement

loading

Related Products for Uni-P Dry H20 200C