Table of Contents
Advertisement
ATTENTION!
Use only original equipment and spare parts from the SaMASZ Company. Parts
from an unknown source or home made are less durable and have a negative
influence on the operation of the plow and work safety.
ATTENTION!
The SaMASZ Company is not responsible for harm or damages as a result of
using non-original parts or equipment.
5. PLOW OPERATION
5.1. Connecting the plow
ATTENTION!
In order to facilitate transport the plows have turned away safety bumpers,
which need to be reserved before operation, as shown in Fig. 10.
5.1.1. Connecting the plow to the tractor
Conditions for connecting the AlpS and Olimp plow to the tractor:
all AlpS and Olimp plows have been designed to be front mounted plows so they can only be
❑
mounted on the front TPH of a category II tractor,
depending on client's needs plow with frame system can be adopted to cooperate with vehicles
❑
equipped with: 3-point linkage category III, EURO, SMS, frame with catches to be welded, custom
linkage as well as other standard excavator-loaders,
plows with no frame system can be equipped optionally,
❑
with category III suspension system which will allow them to be mounted on the rear TPH of a
❑
tractor - in this event it is recommended that the tractor is equipped with a device allowing it to be
driven backwards, a so called "rewers",
the tractor must have a 12 V power outlet (cigarette lighter outlet),
❑
the tractor must have one pair of hydraulic connections.
❑
16
ALPS / OLIMP
Fig. 10. Proper monting of safety bumpers
SNOW PLOW
OPERATOR'S MANUAL
Advertisement
Table of Contents
