Hpl Lamps; Installing The Hpl Lamp - ETC CE Source Four jr User Manual

HPL lamps

HPL lamps are tungsten halogen lamps.
Important: Verify that the HPL lamp you use is suitable for the
voltage at your facility. 230V and 240V HPL lamps are available.
Operating HPL lamps above their rated voltage reduces lamp life
and can cause premature lamp failure.
WARNING! Do not use lamps other than the HPL in CE Source
Four jr/Zoom luminaires. Use of lamps other than HPL will void
CE safety conformity and warranty.
Lamp code
HPL 575/230
HPL 575/240
HPL 375/115
HPL 375/115X
HPL 550/77
HPL 550/77X
HPL 575/115
HPL 575/115X
HPL 575/120

Installing the HPL lamp

Important: The lamp must be installed before you use the
luminaire.
Caution! Always replace the lamp if it becomes damaged or
thermally deformed.
1. Disconnect the unit from power before installing and replacing the
lamp.
WARNING! Let lamp cool before changing.
2. Loosen the knurled bolt on the back of the lamp housing and pull
the housing straight out.
3. Remove the HPL lamp from its box, holding it by the base.
Note: To avoid premature lamp failure, do not touch the lamp glass.
If you do touch the lamp, clean it carefully with rubbing
alcohol and a clean, lint-free cloth before operation.
4. Line up the flat sides of the lamp base with the retention brackets
on either side of the socket. See Figure 3 .
5. Push down on the lamp base until the lamp seats firmly. (The top of
the lamp base will be even with the top edges of the retention
brackets when it is properly installed.)
Watts Volts Color temp Ave rated life
575 230 3,200ºK
575 240 3,200ºK
375 115 3,250ºK
375 115 3,050ºK
550 77 3,250ºK
550 77 3,050ºK
575 115 3,250ºK
575 115 3,050ºK
575 120 3,250ºK
CE Source Four jr & CE Source Four jr Zoom • 7
400 hour
400 hour
300 hour
1,000 hour
300 hour
2,000 hour
300 hour
2,000 hour
300 hour
English
HPL lamp
Lamp
retainers
Lamp
retention
brackets
Lamp housing Knurled bolt
Figure 3