Advertisement
Ceramic Kilns: Caldera, Home Artist, etc.
Please read the instruction manual for more detailed information. For a copy, go to www.paragonweb.com or call
972-288-7557. Press START/STOP at any time to stop a firing. To return to IdLE after the firing is completed, press START.
Cone-Fire Instructions
Fires to a pyrometric cone, then shuts off.
1 From IdLE, press START.
2 Using the Up Arrow key, skip past PrO1, PrO2, PrO3, PrO4
and select COnE. Press START.
3 Use the arrow keys to select the cone number. Then press
START.
4 SPd will appear. Use the arrow keys to select SLO (slow),
_Ed (medium) or FASt firing speed. Press START.
5 HLd will appear. Use the arrow keys to enter the hold time
(hours.minutes). (If not needed, enter 00.00.) Press START.
6 Strt will appear. Press START again. -On- will appear. The
kiln is firing.
L-108/7-07
Paragon Sentry Xpress Quick Start Guide
Ramp-Hold Instructions
Fires up to 8 speeds and temperatures (segments). Controls
heating and cooling.
1 From IdLE, press START.
2 Press the Up Arrow key. Select PrO1, PrO2, PrO3, or PrO4.
Press START.
3 rA 1 will appear. Use the arrow keys to enter firing rate
(temperature change per hour) for segment 1. (1° = slowest
rate. 1799°F/999°C = full power.) Press START.
4 °F 1 or °C 1 will appear. Use the arrow keys to enter the
temperature you are firing to. Press START.
5 HLd 1 will appear. Use the arrow keys to enter the hold time
(hours.minutes). (If not needed, enter 00.00.) Press START.
6 Continue entering values for the segments needed. When rA
appears for the next segment that you don't need, select 0000.
(This will zero out any remaining unused segments.) Then
press START. Strt will appear.
7 Press START again. -On- will appear. The kiln is firing.
Advertisement
