Specifications; Set-Up; Iii. Specifications; Iv. Set-Up - Banner American BA-FS43 Operating Instructions Manual

u
Do not operate the laminator with a damaged power supply cord or plug.
u
Replace fuses only with same type rated 30A, 240V and 1A, 250V fuses. Contact your dealer
for replacement fuses.
u
There are four (4) EMERGENCY STOP buttons on your Finisher 4300, two in the front and
two in the back. Depressing any one of these buttons will stop the rollers.

III. Specifications...

Operating Speed:
Power Requirements
Voltage:
Warm Up Time:
Fuse:
Maximum Laminating Dimensions
Thickness:
Width Capacity:
Net Weight:
Shipping Weight:

IV. Set-up...

Inspection:

Upon receipt of your Finisher 4300, inspect the crate, the machine and all other contents of the crate for
shipping damage. Damage should be brought to the immediate attention of the delivering carrier.

Appropriate Location:

Your Finisher 4300 must be placed on a sturdy table or stand in a clean, well lit area with ample space on all
four sides of the laminator. Contact your dealer for the optional stand designed especially for the Finisher
4300.

Loading Film onto Mandrels

The following instructions apply to poly-in film rolls.
Top Roll: With the brake nut to the right, pull the core gripper blade toward you and place the roll of film onto
the mandrel so that the film unwinds toward you from the bottom of the roll. Turn the roll on the mandrel to
lock the core gripper blade into the cardboard film core.
Bottom Roll: With the brake nut to the right, push the core gripper blade away from you and place the roll of
film onto the mandrel so that the film unwinds toward you from the top of the roll. Turn the roll on the mandrel
to lock the core gripper blade into the cardboard film core.
The core gripper blades on the top and bottom mandrels spring back in opposite directions. The blade should
spring back in the direction that the core will rotate when laminating. When the film is loaded properly the core
gripper blade will prevent the film from turning on the mandrel. To determine top and bottom mandrels, with
the brake nut on the right, the core gripper of the top mandrel will spring away from you. When using poly-in
rolls the top roll of film should unwind from the bottom and the bottom roll should unwind from the top. With
poly-out rolls the top roll will unwind from the top and the bottom roll from the bottom. Once the film is properly
loaded onto the mandrels, replace the mandrels onto the laminator.
Adjustable to 20 fpm (10.16cm/sec.)
Single Phase 208-240 VAC, 50/60 hz
10 minutes
30 A
½" (12.70mm)
43" (1092mm)
370 lbs (136.2 kgs.)
700 lbs (272 kgs.)
3