Laminating & Mounting Do's & Don'ts; Warranty & Return Policy - Banner American BA-FS43 Operating Instructions Manual

XI. Laminating & Mounting
Do's and Don'ts...
Read the instruction manual before operating your laminator.
Always run test samples before laminating valuable items.
Feed the print through slowly and evenly, smoothing it as it is pulled into the laminator.
Operate the laminator with two rolls of the same width laminating film to avoid excessive adhesive transfer
to the rollers.
If laminator is not in current use, lower the heat setting or turn unit off.
To avoid damaging the rollers, the heated rollers should be turned off for most applications after the
laminator reaches operating temperature. Never feed abrasive materials or metal objects such as staples,
paper clips, or glitter through the laminator. Keep sharp objects like scissors and rulers away from the
rollers at all times.
Once an item has been fed between the rollers do not attempt to alter its position as this can damage the
print.
Do not stop the laminator before the item has completely exited from the rear to avoid a "dwell line" across
the print.
Do not clean or service the laminator before disconnecting the power supply.
XII. Warranty & Return Policy...
Warranty:
Your Finisher 4300 is warranted to be free of defects in material and workmanship for a period of 1 year from
the date of original purchase. In the event of a defect in materials or workmanship, Banner American Prod-
ucts, Inc. or its authorized dealer, will repair or replace (at their option) the laminator.
Banner American Products, Inc. makes no other warranty stated or implied except as stated above. This
warranty does not cover damage to the machine that occurs as a result of misuse or improper handling, or
damage to prints.
Return Policy:
If your laminator is not operating properly, first review the Operating Instructions and the troubleshooting guide.
If the malfunction cannot be corrected, contact your local dealer for instructions. Be sure to have your ma-
chine serial number and date of purchase handy.
If the laminator must be returned to the dealer, it is your responsibility to ensure that it is packaged properly.
Shipping damage as a result of improper packaging is not covered under the terms of this warranty.
10