Network Switch Board; Figure 15: Network Switch Board - Fiery E100 Service Manual

C
OMPONENTS

Network switch board

The E100 connects to the copier by means of a network switch board. With this board, you
can create separate IP addresses for the E100 and the copier, which is a required step when
enabling some functions on the E100.
The network switch board connects to the small PCI connector on the motherboard.
F 15: Network switch board
IGURE
T N S
O REMOVE THE ETWORK WITCH
You must follow standard electrostatic discharge (ESD) precautions when you handle
electronic components. For more information, see
precautions" on page 11.
1. Shut down and open the E100 (see
2. Remove the mounting screws that connect the network switch board to the bracket on the
connector panel.
Do not remove the two jackscrews that connect the bracket to the network switch board. Save
the screws for later.
3. Lift the network switch board from the chassis.
4. Place the network switch board on an antistatic surface.
T N S
O REPLACE THE ETWORK
When you handle electronics components, you must follow standard electrostatic discharge
(ESD) precautions. For more information, see
on page 11.
1. Connect the network switch board to the small PCI connector on the motherboard.
2. Secure the network switch board to the bracket on the connector panel with the two
mounting screws that you removed earlier.
3. Reassemble the unit and verify functionality (see
B
OARD
page 14).
B
WITCH OARD
"Standard electrostatic discharge
"Standard electrostatic discharge precautions"
page 18).
37