Iarp Delight Lite Series Use And Maintenance page 18

15.
DISPENSER WASH ASSEMBLY (Optional)
To assemble the dispenser wash, proceed as follows:
Screw in the dispenser wash support (A) with the dispenser wash
(B) using the screw (C) on the back of the equipment.
With water recirculation:
• Fasten the water filling joint (3) with the incorporated
valve, positioned as in the illustration, to the tank (2)
using the fastening nut (4);
• Connect the stainless steel "overflow" tube (7) to the
bushing (6) and fasten it to the tank with the nut (5);
• Connect the water filling joint (3) to the rubber tube to a
tap and fill the tank (2) of clean water;
• Connect the rubber tube to the bushing (6) and drain the
excess water or dirt (filtered from the cover/partition (8))
into a sink.
Without water recirculation:
• Fasten the water filling joint (3) with the valve, positioned
as in the illustration, to the tank (2) using the fastening
nut (4);
• Connect the stainless steel "overflow" tube (7) to the
bushing (6) and fasten it to the tank with the nut (5);
• Connect the rubber tube to the bushing (6) and drain the
excess water or dirt (filtered from the cover/partition (8))
into a sink.
• Manually fill the tank with clean water.
A
C
B
-19-