Iarp Delight Lite Series Use And Maintenance page 14

9.2 INNER CLEANING
These units make an automatic defrosting in the displaying tank.
The storage compartment should be defrosted when frost on the walls has a thickness of more than 5 mm.
We recommend to make the defrosting of storage compartment and, at the same time, the cleaning of displaying
tank; proceed as follows:
1. Place the goods in special refrigerated containers, kept at the same temperature.
2. Unplug the unit.
3. Before cleaning the inside temperature must be equal to the ambient temperature; place a container of warm
but not boiling water inside the storage compartment, standing on a piece of cardboard, and leave the door
closed for about 30 min.
4. Clean the tanks walls with water and neutral soap, rinse and dry carefully.
5. Plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
10. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of
the appropriate pre-established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement
the temperature:
• Press the (C) key in order to see on display the temperature set point.
• Press the (A) key or the (B) key in order to increment or decrement the temperature set point
• Press the (C) key in order to store the new temperature set point.
A) Button to increase temperature
B) Button to decrease temperature
C) Button to show set temperature
D) Automatic defrosting button (press for defrosting start)
E) Light switch
D
C
A B
Electronic control
E
-16-