Complete Connections - Bang & Olufsen BeoVision MX 4200 User Manual

Complete connections

When you set the television up on its own,
simply connect the aerial and connect the
television to the mains.
However, if you are going to connect
speakers, an audio system or any other
equipment to the television, do not connect it
to the mains yet!
When connections are complete and the
cables have been secured as described on this
page, switch on the mains switch on the front
of the television. A tiny, red light appears
above the screen. The system is in standby
mode and ready to be used. If your television
is set up on its own, you can now tune in
programs as explained in the chapter 'First-
time setup of your television' on page 30.
For further information about how to connect
equipment to your television, refer to the
chapter 'The socket panel' on page 46.
Aerial connection
Using an aerial cable, connect your external
aerial (or a cable TV network) to the socket
marked TV on the television's rear socket
panel.
If your television is equipped with the built-in
system modulator, you will notice that the TV
socket shown in the illustration is occupied, and
that there is a second, unoccupied TV socket
located just below a socket marked LINK. Connect
your external TV aerial to this TV socket instead.
Mains connection
Using the mains cable supplied, connect one
end to the socket marked ~ on the rear of the
television, then plug the other end into a wall
socket.
Your television was designed to be left in
standby mode when not in use. Therefore, to
facilitate remote control operation, it is
essential that you leave the mains switch on
(indicated by the red standby light on the
front).
The supplied mains lead and plug are specially
designed for the television, and should be
handled with care. Avoid bending, twisting or
subjecting the cables to pressure or impact. If
you change the plug or in any way damage
the mains lead, it will affect the TV picture
adversely!
Socket panel Standby indicator
BeoVision MX 4200
IMPORTANT! You must fasten the mains cable and
the external aerial cable to the television using the
cable band (A). If this is not done, the lead can be
tugged free of the socket.
45
Mains switch
A