Related Manuals for Agrisan MT 12
Summary of Contents for Agrisan MT 12
- Page 1 SALZBURGER GRAIN MILL MT 12 Owner’s Manual and User’s Guide Before operating the appliance for the first time, please study these instructions and important safe-guards carefully.
-
Page 2: Table Of Contents
Inhalt DEAR CUSTOMER, ..................4 CONTROL ELEMENTS OF THE ELECTRIC GRAIN MILL MT12 ....5 SHORT GUIDE: .................... 8 SUITABLE SITE .................... 9 GRAIN TYPE/CORN TYPE ............... 10 SUITABLE GRAIN TYPES ................11 CORRECT STORAGE OF GRAIN ..............12 DRYING GRAIN: ..................12 MILLING .................... - Page 3 PROBLEM SOLUTIONS ................21 IF NOTHING HELPS ................... 22 WARRANTY....................22 Terms of Warranty:....................23 Warranty claims: ..................... 23 BEFORE YOU RETURN THE APPLIANCE: ..........23 SHIPPING - PACKING: ................24 TECHNICAL DATA: MT 12 ................. 25 RECEIPE ....................26...
-
Page 4: Dear Customer
Give particular consideration to our recommendations on safety, quality of grains and the care of your mill and you will enjoy many years of milling without the slightest problem. Agrisan Naturprodukte GmbH Christine Thurner This mill is designed for the exclusive production of flour and... -
Page 5: Control Elements Of The Electric Grain Mill Mt12
Control elements of the electric grain mill MT12 Hopper Marking for fine adjustment Locking screw Flour spout Mains connection cable On/off switch Please read the operating and safety instruction carefully before using the appliance for the first time... - Page 6 Before using your mill for the first time… There has never been a „naturally-talented “milling expert and so before you begin the milling process, we wish to give you some information on the natural stone – granite – which has been used in your mill. Compared with mill stones manufactured from artificial corundum ceramic material, our natural stone is relatively smooth and reacts sensitively to damp grain.
- Page 7 Reparaturen dürfen nur durch von Agrisan GmbH autorisierte Personen durchgeführt werden. 5. Repairs may only be carried out by persons authorized by Agrisan GmbH. 6. Defective or deficient electrical appliances must not be operated. 7. The seller must immediately be informed of any defects.
-
Page 8: Short Guide
Use, please always turn the motor off immediately. Intended use: Our mill MT 12 is designed and constructed for domestic use. The appliance is intended for the milling of such grain types as listed in the owner's manual. Short Guide: 1. -
Page 9: Suitable Site
Suitable Site The Salzburger grain mill is made of high quality solid beech wood. Wood is a natural product, which during its whole lifetime, is continually subjected to influences of the environment. Change of climate and temperature can cause small cracks in the housing of the mill. However, such cracks will have no effect whatsoever on the mill’s functioning. -
Page 10: Grain Type/Corn Type
GRAIN TYPE/CORN TYPE Please make sure to use only dry and cleaned grain! Moist grain will smear the millstones! (Please see the chapter on smeared millstones). Poorly cleaned grain can include dirt or foreign particles (e.g. small stones etc.), which can damage the millstones. Mill to the desired degree of fineness in one process (except when processing large, hard kernels such as corn). -
Page 11: Suitable Grain Types
Suitable Grain Types Grain type Adjustment Remarks Wheat, spelt, Any degree of Rye has higher oil content and buckwheat, rye, fineness. can therefore not be processed rice, barley, so finely as e.g. spelt or wheat. millet, green spelt Corn and soy Adjust the mill to a Use sweet corn kernels and not popcorn. -
Page 12: Correct Storage Of Grain
Correct storage of grain Since biblical times it has been a known fact, that grain can be stored. This is best done under the following conditions: Humidity under 14 %, temperature under 20 % (the most favourable temperatures are between 5-8 °). -
Page 13: Milling
Milling Your mill does not have a scale with information on finer and coarser adjustment settings. It is impossible to issue a valid scale which would cover all types of grain and at taking the different degrees of dampness into consideration. Wheat and spelt can be processed to the finest degree. -
Page 14: Correct Milling
Correct Milling: 1. Place a suitably large container under the flour spout. 2. Turn the mill on – you will hear the noise of the motor. 3. Turn the thread until you hear the slight sound of the stones grinding against each other. -
Page 15: Adjusting The Degree Of Fineness
Operating time up to 35 minutes Your mill has been designed for processing household quantities. Should you occasionally require an unusual amount of flour that is no problem! However, the mill may turn itself off during the milling process. There is no need to worry, the mill has not been damaged! Leave it to cool off for about 1 hour. -
Page 16: Adjustment Of The Degree Of Fineness
Adjustment of the degree of fineness: At a standstill: Provided there are no grain kernels between the mill stones, any adjustment can be carried out – even when the mill is at a standstill. With the mill turned on fill the grain into the hopper. When the mill is switched off and with a full hopper no finer re-adjustment should be carried out. -
Page 17: Interrupting The Milling Process
During the milling process turn the hopper in the clockwise direction. Watch the flour spout! Should no flour come out of the spout immediately adjust to a coarser setting. IMPORTANT: If even only a slight grinding noise from the mill stones is heard, you have to turn the hopper immediately back to coarser –... -
Page 18: Closing The Milling Chamber
until it can be lifted off the lower part of the mill. Please clean the thread before re-assembling the hopper. The thread is adjusted smoothly and must not be oiled. Oil and flour together leads to bonding of the thread Closing the milling chamber: Re-assembly of the hopper can only be carried out in one position. -
Page 19: Smeared Mill Stones
Smeared mill stones If the grain is not dry enough for the fineness chosen, the millstones may become smeared. A hard smooth layer will form on the outside edge of the stones. To clean the stones, milling 1 or 2 handfuls of rice at a coarse setting will suffice. -
Page 20: Against Moths And Insects
Against moths and insects: Place a tea bag (herbal) in the flour spout. Put bay leaves in the upper and lower parts of the mill. Moths love dark conditions, where they can survive in peace and quiet! They eat only flour and no wood. Provided your mill is frequently used, you will not be offering moths a comfortable place to stay. -
Page 21: Problem Solutions
Problem Solutions Problem Cause Solution Motor is blocked and Mill was adjusted in still- Reset the mill to a cannot be switched on stand mode from „coarse coarser setting and then “to „fine “although whole adjust slowly to a finer grain kernels were setting between the mill stones. -
Page 22: If Nothing Helps
Before returning the mill for repair, contact our customer services department, maybe they will be able to give you helpful advice. Tel. +43 6245 83282 Email: info@agrisan.at Warranty Thanks to many years of experience, us grain mills are produced and controlled directly in us factory. -
Page 23: Terms Of Warranty
Terms of Warranty: The warranty applies to all occurring material or processing defects, and dep ends on the choice of the manufacturer to replace, repair or refund the mill. It does not include the replacement of consequential damage nor loss due to natural wear and tear or to damages caused by the use of force and/or improper use or lack of improper maintenance. -
Page 24: Shipping - Packing
Please return the parcel sufficiently stamped - please also consider taking transport insurance, which does not incur significantly higher postage costs. Warrantor and warranty address AGRISAN NATURPRODUKTE GMBH, Gasteigweg 25, A 5400 Hallein... -
Page 25: Technical Data: Mt 12
Technical Data: MT 12 Milling Capacity fine bread flour (wheat): ca. 200/g min. Milling capacity coarse setting: ein Vielfaches Weight: 12,5 kg Hopper capacity: ca. 1.400 g Ø Space required: 210 mm Height: 430 mm Storage height: 175 mm Coarse-fine-adjustment:... -
Page 26: Receipe
Receipe Bogenhofener whole wheat bread 750 g of ground spelt, 250 g of ground rye, 2 packets (7 g) dry yeast, 4 tbsps. each of sunflower, sesame and linseed seeds, 1 egg, about 1 tbsp. each of salt and bread spice, approximately 600 ml of lukewarm water. - Page 27 AGRISAN NATURPRODUKTE GMBH Gasteigweg 25 A 5400 Hallein Österreich Tel. 0043 6245 83282 E-mail: info@agrisan.at Internet: www.getreidemuehle.com www.veganstar.at www. smoothie-mixer.at www.facebook.com/Getreidemuehlen...
Need help?
Do you have a question about the MT 12 and is the answer not in the manual?
Questions and answers