Control Panel - GE AG16AB2TAA Installation And User Manual

A
CONTROL PANEL DISPLAY
In Auto and Continuous mode，it will indicate the
actual room humidity. In timer mode，it indicates
the setting time.
B
TIMER BUTTON
Note: Before pressing the TIMER button, please
make sure that the timer function has not been
activated (the timer indicator light must be off).
Timer programs are available as the following:
1.Delayed power-on function (Stand-by Mode).
Use the key "UP" or "DOWN" to set the time period
(0-24 hours, 1 hour as a step) after which the unit will
start operating automatically.
2. Delayed power-off function (in operation Mode).
Use the key "UP" or "DOWN" to set the time period
(0-24 hours, 1 hour as a step) after which the unit will
stop operating automatically.
Once you have finished setting the time, the display
will stop flashing after 5 seconds, whilst the timer
indicator light will remain illuminated to remind you
that there is time setting in your unit.
Note: In case you turn your unit off before the set time
has passed, then the delayed power off setting will be
cancelled. In the case that the unit stops working due
to full water tank deactivation, the setting will not be
cancelled.
C
WIND BUTTON
Press the fan speed selection key WIND to select
between: High speed – suitable for fast and high-effi-
cient dehumidifying, suitable for clothes drying function
(the HI-EFFICIENT indicator light will be illuminated).
Low speed – suitable for a quiet (low noise) operation
(the SILENCE indicator light will be illuminated).The
speed selection can be made only when your
dehumidifier is set at AUTO mode.
A
E
B C D F
To set inside drying function
By pressing the WIND key continuously for 5 seconds, an
inside drying procedure of the parts of the device will be
activated. This is an additional function that prevents
from the concentration of mildew or other microorgan-
isms on various parts of the unit and especially on the
compressor and evaporator of the device. When the
inside drying function is activated, your unit will not be
dehumidifying and only the operating indicator light will
be illuminated. This procedure lasts for approximately 45
minutes – when this is completed your unit will be shut off
automatically. To provide a better protection to your
dehumidifier, we recommend that you follow the internal
drying process on your device once every month.
D&E
UP AND DOWN BUTTON
To set humidity
Once you activate your unit, the display will show the
relative humidity level in your room. You may select the
relative humidity level in your unit only when it runs under
AUTO mode.
Press the UP and DOWN keys to program in your unit the
desired relative humidity you wish to have in your room,
right after activating your unit.
You may set a relative humidity level within a range of
30% up to 80% relative humidity with a 5% interval at
every step. Whilst you are programing the humidity
setting the display will be flashing. After finishing the
relative humidity setting, the display will stop flashing
after 5 seconds and will once again show the relative
humidity in your room.
When the relative humidity in your room is 5% below the
one you have set in your unit, then the compressor will
stop working for energy saving purposes. Once the
relative humidity in your room is 5% higher than the one
you have set in your unit the compressor will start
working again after 3 minutes (this delay in the compres-
sor is necessary as a protection system for your unit's
compressor).
5
G