Intertek F18B411 Manual page 8

8
SKU:F18B411 & F18G412 & F18S413
STEP 4
4-1. Attach a reflector stud (CC) and three washers Ø8 (JJ) to the top of the
burrer (C). Tighten the reflector stud.
4-2. Unscrew the four screws that are preassembled on the head assembly (C).
Place the head assembly (C) into the top of the post (D) by inserting the regulator
into the post (D). Tightly fasten the previously removed screws back into the head
assembly (C) through the slots at the top of the post (D).
STEP 5
WARNING
Remove the plastic protective coating on the reflector
panel and centre the reflector before assembling!
5-1. Install the two reflectors with 1 cross bolt M6*8 (BB) and 1 ball nut M6 (AA),
repeat this step to install the third reflector.
5-2. Then install and lock the centre disc and the newly installed reflector
with 6 cross bolts M6*8 (BB) and 6 ball nuts M6 (AA).
STEP 6
6-1. Put Φ8 mm washer (JJ) on each reflector stud (CC).
6-2. Fasten the reflector with 3 washers and 3 wing nuts (DD).
STEP 7
7-1. Lift the tank housing and rest it on the post plate.
7-2. Connect the regulator to the gas cylinder and tighten it with an adjustable
wrench.
7-3. Put the gas cylinder on the base.
8
CC
JJ
C
DD
DD 3
JJ
6
JJ
D