Table of Contents
Advertisement
INSTALL LEFT
SIDE ADAPTER
PACKS WITH
ADAPTERS ANGLED
TOWARD THE LEFT
NYLATCH PLUNGER FASTENERS MUST BE
PULLED OUT BEFORE INSERTING THE
ADAPTER PACK INTO MOUNTING HOLES
3.3
Installing MPO Cassettes
This section describes how to install MPO cassettes in an empty FPX panel. The 1RU panel
accommodates two MPO cassettes, the 2RU accommodates four. To install MPO cassettes, use
the following procedure.
1. Temporarily remove the top cover so as to have access to the inside of the panel.
"OUT"
POSITION
IN PANEL
Figure 11. Installing Adapter Packs
INSTALL ADAPTER PACKS
IN ORIENTATION SHOWN
INSTALL RIGHT SIDE ADAPTER PACKS
WITH ADAPTERS ANGLED TOWARD THE RIGHT
AFTER INSTALLING ADAPTER PACK,
PUSH NYLATCH PLUNGER FASTENERS
"IN" TO LOCK ADAPTER PACK INTO PANEL
ADCP-92-159 • Issue 1 • 2/2015
"IN"
POSITION
25680-A
Page 11
© 2015, Tyco Electronics Corporation
Advertisement
Table of Contents
