Table of Contents
Advertisement
9. General information
(continuation)
9.2. Maintenance and repair
The ultrasonic does not require great maintenance thanks
to the avoiding of the moving parts in this new design.
The only maintenance you have to do is to clean the solar
panel with a wet tissue a few days before using it and
place it in a light source / solar to get the battery full of
charge.
Before using it, make sure that the device has enough
battery to work without problems. You can get that infor-
mation directly through theapplication.
Transducers must be kept clean and aligned. Impacts or
incorrect impulsive handling may lead to transducers
misalignment.
The space around the transducers must be empty and
clean. Dust, frost, water, etc... will make the unit stop
working.
Rinse with freshwater and let dry.
9.3. Warranty
This Warranty covers the defects resulting from defective
parts, materials or manufacturing, if such defects are
revealed during the period of 24 months since the date of
purchase.
Warranty is void in case of non-following the instructions
of use, repair or maintenance without written authorisa-
tion.
This product is for leisurepurposes exclusively. Anywron-
gful use given by the user will not incur in any responsibili-
ty of Calypso Instruments. As well, any harm caused to
ULTRASONIC PORTABLE by a mistaken use will not be
covered by the guarantee. Using assembly elements diffe-
rent from those delivered with the product will void the
guarantee.
Changes on transducers position/alignment will avoid any
warranty.
For further information please contact Calypso Technical
Support through info@calypsoinstruments.com
or visit www.calypsoinstruments.com.
9. General information
9.1. General recommendations
The Ultrasonic Portable has been calibrate with
accurate, following the same calibration standards for
each unit.
Regarding to mount the unit
As we describe you before, you have to prepare the
mast head for the mechanical installation. Align the
North mark of the Ultrasonic in order to have it
heading to the bow.
Then install the sensor in a location free from wind
pertur- bation, usually on the mast head.
Other important aspects
Do not attempt to access the transducer area with your
·
fingers.
Do not attempt any modification to the unit.
·
Never paint any part of the unit or alter its surface in
·
any way.
If you have any questions or doubts, please contact
direct- ly with us. We will be glad to assist you in any
time.
‡alypso Instruments team thanks you for your confidence.
Advertisement
Table of Contents
