Page 3
The M5400 maintains a comfortable temperature above freezing while minimizing power consumption. System Supply Pipe Electrical Connection System Supply Valve “TEST” Button Alarm Light System Drain Valve Heater System Drain Pipe Drain Pipe Cap AGF Manufacturing Inc. • Phone: 610-240-4900 • Fax: 610-240-4906 • www.testandrain.com...
Model 5400 COLLECT DRAIN Owner’s Manual ® INSTALLATION INSTRUCTIONS Unpacking: Unpack the COLLECT DRAIN M5400 unit and carefully inspect for any ® damages from shipping. Verify box contents: • COLLECT DRAIN M5400 unit ® • Four (4) Rubber Mounting Washers •...
Connect one wire to the AC1 (auxiliary contact) Terminal. Connect the other wire to the AC2 (auxiliary contact) Terminal. Connect these wires to the appropriate place in the Remote Panel. AGF Manufacturing Inc. • Phone: 610-240-4900 • Fax: 610-240-4906 • www.testandrain.com...
The default setting of 50º F is adequate for outside temperatures down to 0º F. If operating below this temperature, the set- point should be increased. Consult AGF for set-point guidelines. Install the M5400A Alarm Panel Cover and tighten the four screws securely.
The factory default setting of 50º F is suitable for conditions down to 0º F. Consult with AGF for recommended settings if operating the M5400 in areas below 0º F. The thermostat controls the heater operation to within approximately ± 10º F of the set-point (i.e.
Page 8
Model 5400 COLLECT DRAIN Owner’s Manual ® auxiliary contact is also triggered and is capable of being wired back to a central control panel for remote indication. The Level Alarm is automatically reset when the water level is drained below the switch. The M5400 is equipped with a “TEST”...
120V power is present. Loosen the four screws on the front of the M5400H Alarm Panel Box and carefully remove the cover. Take note of the current thermostat set-point. Thermostat Set-Point: __________________ AGF Manufacturing Inc. • Phone: 610-240-4900 • Fax: 610-240-4906 • www.testandrain.com...
The default setting of 50º F is adequate for outside temperatures down to 0º F. If operating below this temperature, the set- point should be increased. Consult AGF for set-point guidelines. Disconnect electrical power to the M5400.
Need help?
Do you have a question about the COLLECTanDRAIN 5400 and is the answer not in the manual?
Questions and answers