FICEP 1001 DFB Programming And Operating Manual page 216

MACHINE SET-UP
4.7 Recapitulation table of routine maintenance interventions
In the following table are resumed the routine maintenance interventions to
be scheduled on the line. Interventions frequency has been calculated in
working days of system operation.
code intervention description
cleaning
D1 calamine removal from chains of loading and
unloading tables
D2 cleaning of sliding guides of carriage
D3 cleaning of pincher jaws
D4 cleaning of: photocells, reflectors, proximity
transducers, limit switches
D5 cleaning of working units area
lubrication
L1 transmission chains lubrication of loading /
unloading conveyors and infeed/outfeed
rollerways (and topping up if necessary)
L2 check of oil level in loading/unloading tables
reduction gears (and topping up if necessary)
L3 manual lubrication (on appropriate points) of
loading/unloading rollerways
L4 check of oil level in the carriage reduction gear
(and topping up if necessary)
L5 manual lubrication (on appropriate points) of
vices, hold down, rolls on the machine and
guides
L6 manual lubrication (on appropriate points) on
carriage guides
L7 check of oil level in loading/unloading tables
reduction gears (and topping up if necessary)
L8 fluid level check of drills lube cooling system
controls, tightenings, adjustments
C1 check of oil level in the hydraulic power unit
C2 check of lubrication system integrity, grease
arrival points and tightening of the inlet pipes
C3 tightening control of cams, proximity
transducers, limit switches, connectors,
terminals and insulating on electric equipment
C4 control of pipes tightening and check of wear
of flexibles on fluid systems
C5 driving belts control of positioning and
forward axes of the working unit
Page 4-32
1001 DFB
Drilling & Sawing Line
frequency
(system working days)
20
20
2
2
1
30
120
60
120
60
120
120
1
20
120
60
60
15
notes
FICEP