FICEP 1001 DFB Programming And Operating Manual page 174

CONTROLS
11. It qualifies the section width probing
12. It qualifies the web and flanges height probing (optional)
13. Push button to unload MDY tool in Manual Mode
14. It qualifies the pincher automatic clamping of the section
15. Setup of the pincher vertical coordinate in AUTOMATIC mode
16. Setup of the pincher vertical coordinate on the upper side of the
17. Push button to activate the sensitive drilling cycle
18. Push button to load MDY tool in Manual Mode
19. It qualifies the drill (MDY) length pickup with photo cell in
20. Push button for selection of drill head in "A" position. Active only
21. Push button for selection of drill head in "C" position. Active only
22. Push button for selection of drill head in "B" position. Active only
A - It is used to change the password
B - It used to enter the robot commands window
C -It used to enter the saw commands window
D -It used to exit from the operator's window.
Page 3-8
profile
MANUAL mode
in manual mode
in manual mode. Attention: before the machine is switched off, the
drilling head must be moved to "C" position. If this is not attained,
at the next restart, it is not possible to perform the zero cycle and it
is necessary, releasing the head rotation, rotate manually the drilling
head in "C" position
in manual mode
1001 DFB
Drilling & Sawing Line
FICEP