Installing The Dxs Transmitter Batteries (Rtf) - Horizon Fitness BLADE 230 S Smart Instruction Manual

To charge the included flight battery:
1. Using the supplied Type-C USB cable, connect the
S120 charger to a USB power supply (not included).
2. Insert the Spektrum SMART Battery IC3 connector into
the IC2 port of the adapter cable. Insert the addapter
cable IC3 connector into the charger IC3 port (
battery may be disconnected from the charger at any
time to stop the charging process.
IMPORTANT: SMART NiMH batteries do not have a bal-
ance connector.
3. Disconnect the IC3 when the charge cycle is complete,
as indicated by the LED.
4. The LED indicator will glow solid red to indicate a
charging error. Follow the operation steps to ensure
proper connection is used to charge the battery.
Refer to the LED indicator table for charger status.
IMPORTANT: Connecting a non-SMART battery will cause
a charge error and the S120 will not recognize or charge
the battery.

Installing the DXs Transmitter Batteries (RTF)

The LED indicator flashes and the transmitter beeps
progressively faster as the battery voltage drops.
Replace the transmitter batteries when the transmitter
begins to beep.
CAUTION: NEVER remove the transmitter
batteries while the model is powered on. Loss
of model control, damage or injury may occur.
CAUTION: If using rechargeable batteries,
charge only rechargeable batteries. Charging
non-rechargeable batteries may cause the batteries
to burst, resulting in injury to persons and/or damage
to property.
CAUTION: Risk of explosion if battery is
replaced with an incorrect type. Dispose of
used batteries according to national regulations.
A
). . The
Power On
LiPo: Purple LED
A
NiMH: Yellow LED
Charge Complete
Error
5
A
A
LED Indicator
USB 5V: White LED
USB Quick Charge 2.0/3.0:
Blue LED
Battery Capacity
Less Than
Single Flash
25%
25% – 75%
Double Flash
76% – 99% Triple Flash
Green LED (Solid)
Red LED (Solid)
EN