Dxs Transmitter Control (Rtf) - Horizon Fitness BLADE 230 S Smart Instruction Manual

DXs Transmitter Control (RTF)

Aileron (Left/Right)
Mode 1
Throttle (Up/Down)
Aileron (Left/Right)
Mode 2
Elevator (Up/Down)
Bind/Panic Switch
Fli ght Mode Switch
0 = Stability Mode (NORM)
1 = Intermediate Mode (FM1)
2 = Agility Mode (FM2)
LED Indicator
Flight Battery level Indicator
Battery Voltage Level
The included DXS transmitter includes a new flight battery
voltage level indicator feature.
LED SMART Battery voltage indication is based on current
voltage and will change with throttle/power usage. When
throttle is increased, voltage drops, causing the bars to
indicate lower power (e.g., fewer LEDs solid or flashing.)
When the throttle is lowered to idle/off, the bars recover
(e.g., more LEDs solid or flashing). LED bars will rise and
lower depending on throttle/power usage.
The SMART Battery low voltage alarm sounds when the
ESCs are close to reaching low voltage cutoff. The alarm
will sound for 25 seconds. If the throttle is lowered to
allow voltage recovery, the alarm will stop early. Land the
aircraft when the alarm sounds.
After landing, reset the SMART Battery low voltage
warning by either (1) powering cycling the DXS transmitter,
or (2) disconnecting the battery from the aircraft for more
than 15 seconds or until the LED voltage indication bars
go out.
Connect a fully charged battery to the aircraft, which will
ensure the SMART Battery low voltage warning resets
prior to the next flight.
EN
A B
Throttle Aileron
Trim Trim
Elevator Aileron
Trim Trim
G
F
E
C D E
ON/OFF Rudder
Switch Trim
ON/OFF Rudder
Switch Trim
6
F G
Elevator Rudder (Left/Right)
Trim Elevator (Up/Down)
Throttle Rudder (Left/Right)
Trim Throttle (Up/Down)
Throttle Hold
Du al Rate Switch
A
B
C
D