Table of Contents
Advertisement
1. Modes
User mode
PC mode
Clone mode
Mode
User mode
For normal use.
PC mode
Used for communication between the
transceiver and PC (IBM compatible).
Data programming
Used to read and write frequency data
mode
and other features to and from the
transceiver.
PC test mode
Used to check the transceiver using the
PC. This feature is included in the FPU.
Clone mode
Used to transfer programming data
from one transceiver to another.
2. How to Enter Each Mode
Mode
User mode
Power ON
PC mode
Received commands from PC
Clone mode
[PTT]+[Side2]+Power ON (Two seconds)
3. Getting Acquainted
Antenna
LED indicator
Indicates the transceiver
status. Lights red while
transmitting, green while
receiving, and flashes
red while the battery
power is low while
transmitting.
PTT (Push to
Talk) switch
Press and hold,
then speak into
the microphone
to transmit.
Side 1 key
Side 2 key
REALIGNMENT
Data programming
mode
PC test mode
PC tuning mode
Function
Operation
Channel selector
Rotate to change the
operating channel.
Power switch/
Volume control
Turn clockwise to
switch the power ON
and counterclockwise
to switch the power
OFF. Rotate to adjust
the volume.
Speaker/
microphone
jacks
Battery pack
(KNB-45L)
4. PC Mode
4-1. Preface
The transceiver is programmed using a personal computer,
a programming interface (KPG-22/22A), USB adapter (KCT-53U)
and programming software (KPG-88D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
4-2. Connection procedure
1. Connect the transceiver to the personal computer with the
interface cable and USB adapter (When the interface cable
is KPG-22A, the KCT-53U can be used.).
Notes:
• You must install the KCT-53U driver in the computer to use
the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the first time,
plug the KCT-53U into a USB port on the computer with the
computer power ON.
2. When the POWER is switched on, user mode can be
entered immediately. When the PC sends a command,
the transceiver enters PC mode.
When data is transmitting from the transceiver, the red
LED lights.
When data is received by the transceiver, the green LED
lights.
Notes:
• The data stored in the computer must match the model
type when it is written into the EEPROM.
• Change the transceiver to PC mode, then attach the
interface cable.
4-3. KPG-22/KPG-22A description
(PC programming interface cable: Option)
The KPG-22/22A is required to interface the transceiver with
the computer. It has a circuit in its D-sub connector (KPG-22 :
25-pin, KPG-22A : 9-pin) case that converts the RS-232C logic
level to the TTL level.
The KPG-22/22A connects the SP/MIC connector of the
transceiver to the RS-232C serial port of the computer.
4-4. KCT-53U description (USB adapter : Option)
The KCT-53U is a cable which connects the KPG-22A to a
USB port on a computer.
When using the KCT-53U, install the supplied CD-ROM
(with driver software) in the computer. The KCT-53U driver
runs under Windows 2000 or XP.
TK-2200L
3
Advertisement
Table of Contents
