Control 4 C4-KNX-BW180 Series User Manual page 40

Options:
–
Here it is specified how often the brightness is sent on the bus.
Options:
–
No: There is no separate LED object.
–
Yes: There is a separate 1-bit LED object (input) for the option of switching on the LED via
an On telegram and to switch it off with an Off telegram.
Options:
–
No: It is not necessary to calibrate the internal brightness sensor.
–
With daylight adjustment: This adjustment is used mainly for the detector application.
Options:
–
No: Only the most important parameters for setting the brightness detection are displayed.
–
Yes: All parameters are displayed, also those that are not required in most cases.
■
Extended parameters
40
00:00:05 .. 00:00:30 .. 18:12:15
No
Yes
NOTE
Only the LED has been switched. This does not place the device into
programming mode.
No
With daylight adjustment
No
Yes
NOTE
The following parameters are visible only when parameter "Fade in extended
parameters" is set on "Yes".
Description of application and parameters
Application program