Table of Contents
Advertisement
Options:
–
No: The only option available is to change the switch-off delay via the "Brightness reduced
according to switch-off delay" parameter setting.
–
Yes: There is a separate 2-byte brightness reduced according to switch-off delay object
(input) for changing the switch-off delay for the reduced brightness of the detector. The time
entered is in seconds. A switch-off delay of 4 minutes, for example, has a value of 240
seconds.
Options:
–
No: There is no possibility to set the detector to test mode to test the detection range.
–
Yes: There is a separate 1-bit test mode activation object (input) for activating the test mode
with a 1a. The function is reset again with the receipt of a 0 on this object or automatically
after 10 minutes. During the test mode the LED functions as movement detection indicator.
The device operates independent of brightness with a switch-off delay of 2 to 9 seconds.
Options:
–
No: There is no separate actuator status object for connecting with the status of an actuator.
–
Yes: A 1-bit actuator status communication object (input) is being enabled. This is
connected with the status of a switch actuator, for example. When this actuator is switched
off via a central command, the detector is informed and is ready again for switch-on after the
pause time.
30
NOTE
This parameter is only displayed when "Output is of type" is set on 1 byte 0 -
100% or 1 byte 0 - 255.
No
Yes
NOTE
The values which can be sent are between 10 and 65535 seconds. If a value
that is too small or too large is sent, the value is automatically adjusted to the
limit value:
■
Value < 10 -> Value = 10
■
Value < 65535 -> Value = 65535
No
Yes
No
Yes
Description of application and parameters
Application program
Advertisement
Table of Contents
