Advertisement
3.4.
Hot Blower (Refer to fig.1)
3.4.1.
Remove the Soldering Tip by turning anticlockwise. The assembly can now be used as a Hot Blower. (Operation is the same as
above for the Soldering Iron).
3.5.
Flame Adjustment (Refer to fig.1)
3.5.1.
Move the gas volume control towards the higher numbered positions to increase the flame or towards the lower numbered positions
to decrease the flame.
Note: DO NOT start the flame at the higher numbered positions, the longer flame may cause the torch to flare or extinguish. Move the
gas lever to the '1' position and then set up the most efficient flame.
3.6.
Refilling Gas (Refer to fig.1)
WARNING! Take care when refilling.
‰
3.6.1.
Before refilling please make sure the flame is fully extinguished and cooled down. Move the ON/OFF switch to the OFF position.
3.6.2.
Refill in a well ventilated area away from any source of ignition and away from other people.
3.6.3.
Refill with butane gas only, never use unapproved fuels.
3.6.4.
Place the Soldering iron in an upside down position and insert the nozzle of the butane canister into the gas refilling valve.
3.6.5.
Press down on the canister until the gas starts to overflow.
fig.1
Advertisement
