BTC F565E Quick Installation Manual

Quick Installation Guide

Hardware setting

Installation under
Windows Environment

Warning:

The default reading speed is 40X. Pressing Eject button for 3 seconds
will change the speed to 52X. While at 52X mode, pressing Eject
button for 3 seconds or ejecting the tray will reset the drive speed from
52X to 40X.
Using discs with cracks, scratches or of poor quality may cause
damage to the drive and the data in the discs. Such discs may break
during high-speed rotation. If there is any damage of the drive caused
by improper operation or condition mentioned above, you might void
the warranty of the drive.
Be sure to use the screws packed in the accessory bag because
different kind of screws might cause mechanism malfunction.
CD-ROM Drive
1. Turn off the power of PC and unplug the AC
power cord.
2. Remove the
cover of PC
3. Connect the 40-pin IDE cable from one of the
IDE ports on the mainboard to the 40-pin
connector of the drive. Also, connect the
power supply cable to the drive.
4. Re-attach the cover of PC.
5. Plug in the AC power cord.
Reboot the PC.
6.
For operating systems like Windows 95/98/ME and
Windows NT/2000/XP, it is not necessary to install
driver because the systems can automatically detect
the drive and load the appropriate device driver.
.