Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BTC BCE5232IA
Summary of Contents for BTC BCE5232IA
- Page 1 Dual Digital Drive CD-RW 5232IA User’s Manual...
- Page 2 C L A S S 1 L A S E R P R O D U C T A P P A R E I L A L A S E R D E C L A S S E 1 L A S E R K L A S S E 1 L U O K A N 1 L A S E R L A I T E P R O D U I T L A S E R...
- Page 3 FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation.
-
Page 4: Table Of Contents
Table of Contents INTRODUCTION YSTEM EQUIREMENTS ACKAGE ONTENTS INSTALLATION NTERFACE ONNECTIONS ARDWARE NSTALLATION RIVER NSTALLATION For the CD-RW Drive For the Card Reader OFTWARE NSTALLATION Windows Environment CONNECTION & OPERATION RONT ANEL TECHNICAL DATA... -
Page 5: Introduction
INTRODUCTION Thank you for the purchase of CD-RW 5232IA, a perfect and compact dual storage drive with the combination of an IDE CD-ReWritable drive and a USB-connected card reader. CD-RW 5232IA backs up all writing modes and different CD formats. It supports maximum 52x speed writing ability on CD-R discs, 32x speed on CD-RW discs and 52x speed reading performance. -
Page 6: System Requirements
System Requirements For IBM compatible PCs, the system requirements recommended are as follows: ♦ Pentium II 350MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.) ♦... -
Page 7: Installation
Dual Digital Drive INSTALLATION Host Interface Connections Most current mainboards have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four devices, but it is recommended that you separate IDE ports for your hard drive and your CD-ReWritable drive. -
Page 8: Hardware Installation
Hardware Installation 1. Turn off the power to the computer system. 2. Disconnect the power cord and all cables from the back of your computer, and then remove the cover of the computer. 3. Insert the drive into one of the vacant 5.25" drive bays and secure it with screws to your PC. - Page 9 6. Connect the USB cable at the back of the drive to the USB connector on the mainboard. The red wire of the cable needs to plug into Pin 1 on the board. This drive supports USB 1.1 and if you connect to USB 2.0 connector, only transfer rate of USB 1.1 will be available.
-
Page 10: Driver Installation
Driver Installation For the CD-RW Drive For the CD-RW drive itself of CD-RW 5232IA, it is an IDE device supporting Plug & Play, automatically detect the drive and load the appropriate driver. For the Card Reader Windows 98SE/2000 If you run Window 98SE or 2000, please install the provided driver: Insert the application disc. - Page 11 Dual Digital Drive Click “OK” if you have already had USB cable connected (Refer to Hardware Installation, Step 6.)
- Page 12 Dual Digital Drive Make sure to restart your computer. Windows ME/XP Since Windows ME and XP already have USB Mass Storage support, the card reader can be detected and work fine without installing driver. However, we recommend that you install the provided driver to have more explicit operation status of the card reader, as described below.
-
Page 13: Software Installation
After the driver installation, 4 extra icons with different card type indicated will show in Device Manager/My computer. And then you can use each slot of the card reader for file archiving/recording. While the card reader is reading data of memory cards, the icon for the card accessed will light up and the LED beside the card slot on the front panel will flash Green. -
Page 14: Connection & Operation
CONNECTION & OPERATION Front Panel 1. Headphone Jack By plugging in the headphone jack here, you can listen to an audio CD (CD-DA disc) directly playing from the drive. 2. Headphone Volume Control This knob adjusts the audio output level. Turn the wheel to the right/left for the volume control of your headphone. - Page 15 Flashes “red” while writing a CD-R/CD-RW disc. 6. LED Indicator (card reader) Once the USB cable is correctly connected, this LED will light yellow, which means the card slots are ready to use. 7. Slot for Memory Stick (MS)/Memory Stick Pro (MS Pro) 8.
-
Page 16: Rear View
Rear View 1. Digital Audio Output Connector If your sound card has a digital audio IEC958 format connector, you can connect it to this digital audio output connector with a 2-pin audio cable. 2. Analog Audio Output Connector This connector allows you to connect the drive to your sound card with a 4-pin audio cable. - Page 17 5. Power Supply Connector By plugging the computer’s power supply cable here, you can connect the drive and your computer system. 6. USB Cable Connect the USB cable to the USB connector on the mainboard. The red wire of the cable needs to plug into Pin 1 on the board.
-
Page 18: Technical Data
TECHNICAL DATA Interface Form factor Writing speed Writing modes Digital Media CD format support Transfer rate CD-RW Drive Card Reader Data buffer CD-RW Drive: IDE Card Reader: USB 1.1 5.25" Half Height CD-R: 8X/16X/24X/32X/40X/48X/52X CD-RW: 4X/10X/12X/16X/20X/24X/32X TAO (Track at once), DAO (Disc At Once), SAO (Session at once), Multi-session, Incremental Packet Writing... - Page 19 Access time Disc loading Audio output level Power Dimensions Height Width Depth Weight Disc Specification Capacity 120mm disc: 74min 80min 90min 80mm disc: 18min 21min 90ms at ⅓ stroke(52X CD-ROM) 180ms at full stroke(52X CD-ROM) 99ms at ⅓ stroke (32X CD-RW) 200ms at full stroke (32X CD-RW) Tray (motorised), Dust Sealed Line out = 0.6 ±...
- Page 20 Environment CD-RW Drive Temperature Operating Non-operating Humidity Operating Non-operating Card Reader Temperature Operating Non-operating Humidity Operating Non-operating 5°C to 45°C -20°C to 60°C 8% ~ 80%RH 5% ~ 95%RH 0°C to 40°C -20°C to 45°C 0% ~ 90%RH 0% ~ 95%RH...
- Page 21 3100551760 Version 1.0 June 2003...