C L A S S 1 L A S E R P R O D U C T A P P A R E I L A L A S E R D E C L A S S E 1 L A S E R K L A S S E 1 L U O K A N 1 L A S E R L A I T E P R O D U I T L A S E R...
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
INTRODUCTION Thank you for the purchase of 5224UI, a high-performance external CD- ReWritable drive of USB 2.0 interface. It supports maximum 52x-speed writing ability on CD-R discs, 24x-speed on CD-RW discs and 52x- speed reading performance. The drive backs up all writing modes and different CD formats and it automatically recognizes the media placed in the drive, whether a CD, a CD-R or a CD-RW.
One other benefit of USB is plug and play. That is, when you plug the USB device in, it is automatically detected, drivers installed and then ready for operation USB 2.0 supports data transfer at up to 480Mbps for high-speed devices.
INSTALLATION Hardware Installation 1. Connect the power adapter and the AC power cord to the drive. 2. Attach the USB 2.0 cable to the CD-ReWritable drive. USB Connector 3. Attach the other end of the USB 2.0 cable to the USB port in your computer.
♦ It’s advisable not to disconnect the CD-RW drive or unplug the power to the drive while a CD is inserted. ♦ Don’t connect more than two CD-RW drives of USB connections to a single computer. Driver Installation Windows Environment This USB 2.0 External Drive CD-RW 5224UI is a Plug and Play device, and Windows 98SE/ME/2000/XP can automatically detect the drive and load the appropriate driver.
CONNECTION & OPERATION Front Panel 1. Headphone Plug By plugging in the headphone jack here, you can listen to an audio CD (CD-DA disc) directly playing from the CD-ReWritable drive. 2. Headphone Volume Control This knob adjusts the audio output level. Turn the wheel to the right to increase the audio volume of your headphone.
5. Emergency Eject Hole When the Close/Eject button can’t work properly and the disc tray can’t be opened, you can insert a paper clip or a small rod into this hole for manual ejection. Please make sure to power off the system before you do that.
TECHNICAL DATA Performance Transfer rate Access time Data buffer CD format support Writing modes Writing speed Specification Interface Disc loading Power Requirement Read: 7800kb/s (up to 52X) Write: CD-R 7800kb/s(up to 52X) CD-RW 3600kb/s(up to 24X) 85ms at ⅓ stroke(52X CD-ROM) 180ms at full stroke(52X CD-ROM) 99ms at ⅓...
TROUBLESHOOTING To help you get more familiar with this USB 2.0 external drive, CD-RW 5224UI, the following FAQ lists some common problems you might have. Please read it for reference before you request RMA support from your dealer. Q1. 5224UI cannot be recognized. (1) The drive might not be connected properly.
Page 14
Q6. The external speaker doesn’t have sound when playing music CD. (1) Please check if the audio cable is connected to the audio connector properly. (2) Check both rear side of the CD-RW drive and sound card on M/B (If Audio chipset is on board).
Page 15
(3) Select good quality and high-speed supported blank discs. (4) Increase main memory capacity. (5) Select other burning software. (6) De-fragment the hard disk. (7) Keep the source & destination discs clean. (no scratches, fingerprints or contamination.) (8) Copy data as image file to hard drive to avoid buffer underrun. (9) Keep the system clean.
Need help?
Do you have a question about the BCE5224UI and is the answer not in the manual?
Questions and answers