Table of Contents
Advertisement
4. If applicable disconnect the cables.
NOTE:
The procedure to remove a riser 1a or 1b is similar.
Steps
1. Using a Phillips #1 screwdriver, remove the screws that secure the expansion card riser 1.
2. Holding the blue touch point and handle, lift the expansion card riser from the riser connector on the system board.
Figure 38. Removing the expansion card riser 1
Next steps
Replace the expansion card riser
Installing the expansion card riser 1
Prerequisites
NOTE:
You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4. If applicable, reconnect the cables.
NOTE:
The procedure to install a riser 1a or 1b is similar.
Steps
1. Align the screw holes on the riser with the screw holes on the chassis.
2. Lower the riser firmly until the riser card is fully seated in the slot.
1.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
37
Advertisement
Table of Contents
