KX-TCD440HGS / KX-TCD440HGT / KX-A144EXS-1 / KX-A144EXS / KX-A144EXT-1 / KX-A144EXT
5 BATTERY
5.1.
Battery Installation
1. Insert the batteries negative (-) terminal first.
2. Close the battery cover.
Note:
· Use only rechargeable P03P (Ni-MH)/P03H (Ni-Cd) batteries.
5.2.
Battery Charge
Place the handset on the base unit for about 7 hours before initial use.
When the batteries are fully charged,
Note:
· Clean the charge contacts of the handset and base unit with a soft, dry cloth, otherwise the batteries may not charge
properly. Clean if the unit is exposed to grease, dust or high humidity.
· If the handset is turned off, it will be turned on automatically when it is placed on the base unit.
Note for Service:
· The battery strength may not be indicated correctly if the battery is disconnected and connected again, even after it is fully
charged.
· In that case, by recharging the battery as mentioned above, you will get a correct indication of the battery strength.
flashes. When charging, the battery icon is shown as follows.
8