Important notices - This product must be installed in accordance with applicable national and local electrical and construction codes by a person familiar with the construction and operation of the product and the hazards involved. Failure to comply with the following installation instructions may result in death or serious injury. Questo prodotto deve essere installato secondo le normative locali, da personale specializzato.
Fixing Ø286 > 0 mm. DRAINAGE MATERIAL Never install the formwork MATERIALE DI DRENAGGIO below ground level ! Ø345 Non installare la cassaforma al di sotto del livello del suolo ! Aim this sticker towards the wall that should be illuminated.
Page 4
Beam aiming -Beam angle can be varied from -10° to +10°. Remove all the screws from the flange and move the LED surface by pushing it with your fingers. Once achieved the aiming required, it is recommended to power up the opened fixture for few minutes in order to let escape the internal moisture, then close it.
Page 6
Setup -The fixture must be configured only by using AL1321 IR remote control ( sold separately ) and from any DMX-RDM compati- ble controller. -Il proiettore deve essere configurato solo utilizzando AL1321 IR remote control ( venduto separatamente) oppure tramite una centralina DMX-RDM 5’...
· On/Off identifi cation: questo comando è usato per rintracciare l’unità sulla quale si vuole operare ( il proiettore si metterà in evidenza accendendo tutti i LED a massima intensità). · Manufacturer: viene mostrato in nome del produttore ( Griven ). · Model description: viene mostrato il modello del proiettore.
Page 8
Polar Edition features ( only for PE fi xtures ) The POLAR Edition is fi tted with a thermal glass which is particularly useful for outdoor applications. In fact, by warming up, the glass melts ice and snow which might interfere with the projection. When the projector is on, if required by the weather conditions, the glass is automatically warmed up.