Cooktop Installation; Before You Call For Service - IKEA SARDRAG Manual

Cooktop Installation

1. Visually inspect the cooktop for damage. Also
make sure all cooktop screws are tight (see
Figure 7).
2. Install the retainer brackets. See Figure 8.
The retainer brackets MUST be installed, to
meet local codes or, in their absence, with
the National Electrical Code ANSI/NFPA No.
70—latest edition (see Figure 8).
Countertop
Cooktop
Spring
Spacer
Retainer
Bracket
Figure 8
3. Set the cooktop into the countertop cutout.
A
Figure 9
During the installation with a wide cutout make
sure the cooktop is centered. A and B gap should
have the same dimensions. The elongated holes
on the bottom of the installation brackets are
made to fit every cutout.
10
Screws
Figure 7
2mm
Screw 1
B
WARNING!
Do not remove the spring spacers on
the edges of the cooktop. These spacers
center the cooktop in the space provided.
The cooktop must be centered to prevent
excess heat buildup that may result in heat
damage or fire (see Figure 10).
4. Fix the cooktop to the bracket using the screws
supplied (see Figure 10).
Hole located
Spring
under the
Spacer (8)
burner box
to fix the
retainer
bracket.
Screw 2
Position brackets on
unit cutout center
line as shown.
Figure 10
Checking Operation
Refer to the User manual for operation.
CAUTION!
Do not touch cooktop glass or elements.
They may be hot enough to burn you.

Before You Call for Service

Read the Before You Call for Service Checklist and
operating instructions in your User manual. It
may save you time and expense. The list includes
common occurrences that are not the result
of defective workmanship or materials in this
appliance.
Refer to your User manual for service phone
numbers.
Retainer bracket (2)
AA-2194923-3