Using The Built-In System Restore; Built-In System Restore (Step-By-Step) - Logicube Falcon-NEO Application Note

Application Note
12. A confirmation screen will appear. Tap Yes.
13. The Falcon-NEO should gracefully shut down and will turn itself off. The System Restore
process should now be complete. Disconnect the USB keyboard and turn the Falcon-NEO on to
make sure it boots properly.
14. The latest software should now installed. Follow

4.0 Using the built-in system restore

Use this method only if you have previously performed the System Restore
version 3.2u3. If you are not sure whether you have previously performed
the System Restore version 3.2u3, please use the method in
The Falcon-NEO has a built-in system restore. This method requires a USB keyboard.

3.1 Built-in system restore (step-by-step)

1. Disconnect all drives and adapters connected to the Source or Destination ports.
2. Connect a USB keyboard to one of the two front USB ports.
3. Turn the Falcon-NEO on. The Falcon-NEO will display a logo, then beep, then on the top-left of
the screen a 3, 2, 1 countdown will appear
4. When the 3, 2, 1 countdown appears, press and release the Esc key on the keyboard. A grub
bootloader menu will appear.
5. Use the arrow keys on the keyboard and highlight System Recovery then press the Enter key.
Falcon-NEO System Restore v3.2u3
Revised date: December 2020
Logicube, Inc. • 19755 Nordhoff Pl.,Chatsworth, CA 91311 USA• tel:+1-818-700-8488• fax:+1-818-435-0088
Section 5.0
www.logicube.com
to check for a firmware update.
Section 4.0.
Page 9 of 12