Connecting The Hardware - Axis 213 PTZ Installation Manual

AXIS 213 Installation Guide
Please observe the following before installing the AXIS 213 PTZ Network Camera.
• This product is designed for indoor use or in locations where it is protected from rain and moisture. To
operate the camera in these conditions, use the outdoor housing accessories.
• Do not use strong or abrasive detergents when cleaning the casing. Use a mild detergent and wipe
gently.
• Never position the camera directly towards the sun or other bright objects. Whether the camera is in use
or not, never aim it at the sun or other extremely bright objects.

Connecting the Hardware

If the AXIS 213 is to be mounted in a position where it is difficult to access, it is
recommended that you set the IP address and get the camera up and running before
completing the hardware installation, i.e. skip step 1 below until the installation is
completely verified.
The AXIS 213 PTZ Network Camera is supplied with a bracket for ceiling mounting.
1. Drill two holes in the ceiling and
secure the bracket with the
appropriate screws according to
the ceiling material.
2. Connect a standard network cable
to your AXIS 213 and connect it to
the network.
3. Optionally connect the Connection
Module (not supplied) to the
camera.
4. Connect the power cable.
5. The hardware installation is now
complete, proceed to Setting the IP
address, on page 4.
Note:
If the AXIS 213 is to be placed upright on a desktop, remove the four screws on the underside of the
unit to remove the bracket. Place the adhesive plastic feet by the screw holes.
AXIS 213 - Installation Guide
3