The Axis Internet Dynamic Dns Service - Axis 213 PTZ Installation Manual

The AXIS Internet Dynamic DNS Service

The AXIS Internet Dynamic DNS Service is a free service provided by Axis. This
service allows you to quickly and simply install your camera, which then receives a
static name (DNS name) and a dynamic IP address. More information about the AXIS
Internet Dynamic DNS Service is available at www.axiscam.net
To perform this procedure, your network should have an Internet connection with no
HTTP proxy, and IP addresses should preferably be assigned via DHCP.
1. Connect the AXIS 213 to your local network, using a standard network cable.
2. Connect power to the camera.
3. Wait 60 seconds and, using a suitably pointed object, push the reset button on
the underside of the camera once.
4. Visit www.axiscam.net where you will be guided through the remainder of the
installation. Please have the serial number of your product ready and follow the
instructions on the screen.
The serial number/MAC address (S/N) is located on the label on the underside of the AXIS 213
5. Enter a password for the root user (administrator).
6. If required, accept the installation of AMC onto your workstation. See AXIS
Media Control (AMC), on page 9 for more information.
7. The installation is now complete.
Note:
Please note that this procedure will send the IP address, firmware version, product type, serial
number and HTTP port number of the PTZ network camera to the AXIS Internet Dynamic DNS
Service. No personal information is transferred.
To remove the DNS name and unregister from this service, open the Setup pages in
the PTZ network camera, click System Options > Network > TCP/IP > Basic, click the
Settings button for the AXIS Internet Dynamic DNS Service and finally, click the
Remove button.
AXIS 213 - Installation Guide
7