Table of Contents
Advertisement
FOR MISSING PARTS, PLEASE CALL CUSTOMER SERVICE AT 1-800-527-0717.
Tools required to assemble your cooker:
2 Adjustable wrenches
OR
Adjustable wrench and the following
wrenches:
• d" Open end wrench
• w" Open end wrench
• f" Open end wrench
PARTS LIST:
1 Owner's Manual
1 Cooker Stand
1 Burner Assembly
1 Hose & Regulator with Safety Tag
POL
Fitting
Air Hole
NOTE: Make sure the male SAE fitting on the
cooker is screwed into the air shutter
and tightened securely. Do not
over-tighten as the air shutter needs
to move freely in order to adjust air
intake. Check the attachment for
proper connection every time propane
tank is connected to cooker.
3
ASSEMBLY INSTRUCTIONS
READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY
BEFORE ASSEMBLING OR OPERATING YOUR COOKER.
Inspect contents of the box to ensure all parts are included and undamaged.
(Proof of purchase will be required.)
Female
SAE
Fitting
Rotating
Air Shutter
Cooker Stand
Step 1
Remove nut from bottom of burner assembly.
Step 2
Position the stand upside down as shown.
Step 3
Place burner assembly
inside stand with
threaded bolt protruding
through support strap
as shown.
Step 4
Thread nut onto bolt and securely tighten. Do not overtighten.
Step 5
Set cooker with burner assembly upright on flat surface. Make
sure burner assembly is securely attached to cooker.
Step 6
Attach female SAE fitting on
hose assembly (using w"
wrench) to the male SAE fitting
on the burner (using d"
wrench). Hold the male SAE
fitting securely with one wrench
and turn the female fitting with
the other wrench until they are
tightly joined.
PROCEED TO "GAS LEAK TESTING" SECTION ON PAGE 4.
Advertisement
Table of Contents
