Using Your Kettle - Lagostina BW731D51 Instructions For Use Manual

Using your kettle

1) Place the kettle base on a stable, clean surface away from heat sources. Connect the
plug into an outlet.
Note: The kettle (a), kettle base (b), and limescale filter (e) are specifically designed
to be used together and other accessories not designed for use with the kettle should
not be used.
2) Open the lid by pressing the lid release button (f) on the handle (g) (fig. 2). Fill the
kettle with the desired amount of water (fig. 3).
Close the lid (c) by pushing the lid plastic cover (d).
CAUTION: The lid can be hot. Do not touch the stainless steel part
of the lid. Always push the lid plastic cover (d) to close the lid.
Notes:
• Always remove the kettle from the base before filling it with water.
• Never use without water or fill with liquids other than water. When filling the kettle,
take care to not expose the electrical connections at the bottom of the kettle to water.
• You can also fill the kettle with water through the spout.
• Do not fill the kettle beyond the maximum level, or below the minimum level marked
on the water level indicator (h) If the kettle is overfilled, boiling water may splash outside
of the kettle.
• Always use the kettle with its lid closed.
3) Place the kettle on its base.
4) Press the On/Off switch (i) located at the bottom of the kettle under the handle (g).
(fig. 4). The blue LED light on the water windows (h) will switch on. The boiling cycle
starts.
5) At the end of the boiling cycle, the blue LED light will automatically turn off and the
On/Off switch (i) will go back to the Off position.
Note: At any time during the boiling cycle, you can manually stop the boiling cycle,
simply by lifting the On/Off switch (i) to its Off position.
6) Remove the kettle from its base before pouring.
7) To avoid the risk of splashing, pour boiled water slowly and don't over-tilt the kettle.
CAUTION: A dry boil cut-off system will automatically switch the
kettle off.
4