Operating Your High Pressure Washer; Connection Of High Pressure Hose; Mounting Of Spray Lance And Click&Clean Nozzles; Water Connection - Hornbach AQUA 1100 Manual

4 Operating your high pressure washer

DE
B
EN
CS

4.1 Connection of high pressure hose

B1
SK
B2
4.2 Mounting of spray lance and Click&Clean nozzles
B3
The spray lance has a built-in low pressure nozzle that can be used for fl ushing away
dirt.
B4

When attaching the click & Clean nozzles, the pawl on the side of the spray lance should come
out again. The nozzle should stay in position when pulling it.
B5
The foam sprayer features a swivel lock, which must be positioned in the hole in the Click &
Clean spray lance. Press the pawl to detach the Click & clean nozzles and the foam sprayer.

Before starting the cleaning job, check that the machine is in an upright position and placed on
an even surface. Do not place the machine in high grass!

4.3 Water Connection


Connecting to pressurized water supply
The inlet water max. pressure is 1 MPa/10 bar and the max. temperature is 40°C – see rating
plate. An ordinary ½" garden hose of min. 10 m and max. 25 m will be suitable.
B6
B7
Connection to the drinking water mains according to national and local regulations.
Let the water run through the water hose before connecting it to the machine to prevent sand
and dirt from penetrating the machine.
B8
Connecting to pressure less water supply
The machine can also operate in suction mode, meaning that you can connect the machine to
e.g. rainwater vessels, rivers, lakes and cisterns etc. When taking in water from non drinking
water mains the backfl ow preventer is not needed.
26
See the pictorial quick reference guide – operating your high pressure washer.
Attach the high pressure hose (4) to the spray handle (7). Detach the high pressure hose
by pressing the pawl (A).
Mount the high pressure hose on the outlet (3).
Push the spray lance (6) into the spray handle and screw it on.
When attaching the nozzles (8, 9, 10), press the nozzles into the spray lance.
Push the foam sprayer (11) into the spray lance.
Check that the fi lter is fi tted in the water inlet pipe and that it is not clogged up.
Connect the water hose to the water supply by means of the quick connector. Turn on the
water.
Turn off the water and connect the water hose by means of the quick coupling to the wa-
ter inlet.
NOTE!
IMPORTANT!
NOTE!
IMPORTANT!
IMPORTANT!
Original Instructions