Related Manuals for Proxess CX Series
Summary of Contents for Proxess CX Series
- Page 1 CX- SERIES Introducing EZ Connect SERVICE MANUAL To learn more: visit www.proxess.com or call 303-317-6656...
- Page 2 CX-SERIES INSTALLATION INSTRUCTIONS A. CHECKLIST (4 AA Batteries Included) FOR DOOR AND FRAME PREPARATION INSTRUCTIONS, SEE APPENDIX A OR GO TO PROXESS.COM Parts List: Each Proxess CX-Series lockset includes • Door Preparation Template • Cylindrical Lever Lockset with Installation Instructions •...
- Page 3 B. ADJUST FOR DOOR THICKNESS Remove through bolt posts from chassis. Pull chassis and rose mounting plate from exterior lock assembly. PLEASE NOTE THAT THE LOCK BODY COMES PRE-SET TO ACCOMMODATE A 1¾ INCH DOOR Anti-Rotation Tabs on the rose mounting plate Please follow the steps below: Rotate exterior rose mounting plate toward cylindrical chassis.
- Page 4 Hardware Installation Steps STEP 1 STEP 4 (To Re-hand if Necessary) Install the latch in the door with the SP2 screws provided. The To re-hand the lock chassis, begin by removing both latch tube prongs should project into the chassis hole. the through bolt posts.
- Page 5 *RS-485 Option boards will have a 4th cable to connect to the EZ Connect board located on the left side of the board. STEP 6B Deadbolt Configuration For information about installing the Proxess Cylindrical Lockset with a deadbolt, see “Door Preparation and Installation” in the CX-Series Service Manual available at proxess.com.
- Page 6 STEP 10 STEP 12 Install the four AA batteries, beginning with the outer two. Install the levers onto the outside and inside of the door. See tips for installing and removing exterior handle in the CX-Series Service Manual prior to installation. Insert first Insert last After the batteries are properly installed, the lock should beep...
-
Page 7: Door Preparation
Doors: Steel or Wood Door thickness range: 1-3⁄8" (35mm) ~ 2" (51mm). Match the Backset of your Proxess CX-Series lockset to the corresponding installation (either 2-3⁄8" [60 mm] or 2-3⁄4" [70 mm] Backset). Place the installation template onto the door and mark holes. Drill the 2 1⁄8" (54 mm) first, then drill the two 5/16" (8mm) holes for lock chassis mounting. -
Page 8: Additional Resources
Product Marketing Name: CX- Series Cylindrical Lockset IC ID: 22335-PXH01 Contains: SH6MDBT50Q Models (HVINS): PXHO1-CX03-B (Proxess CX-Series Wireless Cylindrical Lockset), PXH01-CX03-DC (Proxess CX-Series DC Powered Lockset), PXH01- MX02-B (Proxess MX-Series Wireless Mortise Lockset), PXH01-MX02-DF (Proxess MX-Series DC Powered Mortise Lockset) UL STATEMENT (Pending)
Need help?
Do you have a question about the CX Series and is the answer not in the manual?
Questions and answers