HAEGER D'Italia Instruction Manual page 8

Make Hot Water
With this function, you can pre-heat your coffee cup to ensure that the
temperature of the coffee will not decrease so as to improve the coffee flavour.
Clean your coffee cup. After drinking coffee, you can directly make hot water
with this coffee maker to clean the cups. This makes it more simple and
convenient to clean the cups.
1. Press the On/Off switch to the "1" position; the Steam switch to "0" position,
Coffee/hot water selector to "0" position. The red lamp will be illuminated;
waiting for a moment, the green lamp will be illuminated.
2. First, turn the steam control knob from "OFF" to "0" position in anti-clockwise.
(Turn the knob with at least 135 degree.) Then press coffee/hot water
selector to "1" position, and hot water will flow out from the steam wand.
Producing Steam to Heat liquids
The steam wand (without the frothing device) can be used to make hot
beverages like drinking chocolate, water or tea.
1. Open the tank cover, remove the detachable tank and fill it with desired
water, the water level should not exceed the "MAX" mark in the tank. Then
place the tank into the appliance properly.
2. Replace the tank, then connecting the appliance to power supply source.
3. Press the ON/OFF switch to the "1" position, the red lamp is illuminated.
4. Turn the steam control knob to "OFF" or "0" position, make the coffee/hot
water selector on the "1" position, the pump will pump water, when there is
water flowing out, close the coffee/hot water selector to the "0" position
immediately, pressing the steam selector to the "1" position and waiting for
a moment, the appliance begins to be heated until the green lamp is
illuminated, it shows the heating is finish.
5. Remove the frothing device from the steam wand.
6. Dip the steam wand into the liquid to be heated. Turn the steam control
knob in anti-clockwise slowly to start making steam.
7. When the required temperature is reached, you can turn the steam control
knob to "OFF" or "0" position.
8. Press the ON/OFF switch to the "0" position to cut the power source off.
Instructions for use
English
6