AVERATEC D1002 User Manual page 40

3. On the following screen, enter the password and then press <Enter>.
Then enter the same password again and press <Enter>.
4. If you entered the correct password, the following window will appear. Press <Enter>.
This completes setting up a password.
The Supervisor Password is at a higher level than the User Password.
Supervisor Password is
Shows the setup status of the Supervisor Password: Installed, if a upervisor Password is set, or
Not Installed.
User Password is
Shows the setup status of the User Password: Installed, if a User Password is set, or Not
Installed.
Change Supervisor Password
Setting up a password helps you prevent unauthorized users from accessing the system. In the
factory settings, no password is installed. A password can have up to six alphanumeric
characters and/or numbers.
Enter New Password
Confirm New Password
Password installed
[OK]
31