Change User Password; Change Supervisor Password; Resetting The Cmos To Default Settings; Exiting And Saving - AVERATEC AV2225-EH1 User Manual

Appendix A

Change User Password

With a User password, you can enter the Setup Utility and change or
remove the User password, but you cannot enter the Setup Utility and
change or remove the Supervisor password, nor enable diskette
access if it has been disabled.

Change Supervisor Password

A supervisor password must be set before a lower-level user
password can be set. After selecting Change Supervisor Password,
press Enter. You will be prompted for the new password, and then
again to verify it. Type in 6 or fewer keystrokes. If you make an error,
press Esc to start over.

Resetting the CMOS to Default Settings

The main page provides the system parameters for you to reset the
CMOS to default settings. After you enter this page, select the Load
Optimal Defaults:
Select [OK] to reset the CMOS to default settings.

Exiting and Saving

Save Settings Select this option to save changes to the field
values, and restart the computer using the new
and Exit
values. (Pressing F10 from any of the menu
screens also allows you to save settings and exit.)
Exit Without Select this option to discard any changes you have
made to the field values, and restart the computer
Saving
using the old values.
Load Optimal Defaults?
[OK] [Cancel]
56