Advertisement
5.10 NTC with Thermal Protector
a) Remove turbofan. NTC is at the end of the heater group
b) Remove the power connector that is connected.(NTC on the left, on the right is the
thermal protection cable)
c) Pull and remove NTC locking pin
d) Pull NTC out from heater assembly to unclip off of the element
5.11 Air Break
a) Remove the left side panel of the machine
b) Open machine's door
c) From inside the machine, rotate air break nut counter clockwise and remove it
d) Remove air brake connectors with salt cap as it is shown in picture
Take care, plastic components
Page 36
Advertisement
