Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Hornady AUTO CHARGE PRO
Summary of Contents for Hornady AUTO CHARGE PRO
- Page 1 INSTRUCTIONS AUTO CHARGE ® Item No. 050053...
- Page 2 • Internal components are very sensitive. Do not shake, drop, or overload unit. • Handle unit with care, treating it as the sensitive instrument it is. • If spilled powder gets inside unit, do not operate. Call Hornady Customer Service at 1-800-338-3220.
- Page 3 PARTS LIST Powder Hopper Lid LCD Touch Screen Powder Hopper Powder Empty Spout Draft Cover Calibration Weight Calibration Weight Bubble Level Leveling Feet Brush 9V Power Supply -US Plug Adapter 220V Plug -EURO Plug Adapter Converter...
- Page 4 QUICK START • Verify unit is properly assembled with scale plate, powder pan, and clear powder hopper in place. • Turn unit on by removing the powder pan, plugging it in and pressing black power button on front of unit. For best performance, allow unit to stabilize for 5-15 minutes before use.
- Page 5 KEYPAD BUTTON FUNCTIONS ON/ OFF (mechanical button): Tap to turn on. Hold for three seconds to turn off. ZERO/CALIBRATE: Tap to zero scale. Hold for three seconds to calibrate. DISPENSE: Tap to begin or pause dispensing target amount, hold to trickle. AUTO/MANUAL: Tap to switch from AUTO to MANUAL mode.
- Page 6 KEYPAD BUTTON FUNCTIONS (continued) UNITS: Tap to select measurements in GRAINS (gn) or GRAMS (g). Hold for 6 seconds to turn button beeps off. This will not turn the beep at the end of a powder charge off. ENTER: Enter target amount using numeric keys, then press ENTER to store Target Weight and to store any custom settings.
- Page 7 CALIBRATION • For optimal performance, turn unit on and allow 5-15 minutes to warm up. • Verify powder pan has been removed, and that the red scale plate is empty. • Press ZERO/CALIBRATE button for three seconds until unit displays “CAL ---“. •...
- Page 8 CLEANING It is very important that the powder is cleaned out of the Auto Charge Pro after each use. The Auto Charge Pro should not be used as a powder storage device. To easily clean out the unit perform the following steps.
Need help?
Do you have a question about the AUTO CHARGE PRO and is the answer not in the manual?
Questions and answers