Siemens Sm@rt DAS User Manual page 16

Chapter 4
Communications
Using the Sm@rt DAS Communication Module
At the top of the screen, type in the controller IP address
(default is 192.168.0.74) [1] and breaker number you want
to change settings on. This value will be between 1-10 [2].
Then click "Read States"[3]*. For VL breakers, you can change
the three settings highlighted in [4] as well as activate DAS.
For WL breakers, you can only activate DAS[4]. Once new
settings are entered, click "Write States"[5]. You can verify the
new settings on the module and breaker by re-running read
states. For changing VL settings, it is recommended to put the
breaker in DAS mode (either via switch or the software) and
check states on the breaker to verify the new settings.
* You must read states in order to change the settings.
1.
Figure 4.6: Sm@rt DAS MODBUS Communication Module Steps
16
3.
2.
4.
5.