DeWalt DCP611 Safety & Use Instructions

DeWalt Corded Router
Model DCP611
Safety & Use Instructions
Do not wear loose clothing, jewelry or long hair when using this tool.
•
Hold power tool by insulated gripping surfaces, when performing an operation where
•
the cutting accessory may contact hidden wiring.
Use clamps or other practical way to secure and support the workpiece to a stable
•
platform.
Wear safety glasses or ANSI Z87.1 compliant safety goggles.
•
Keep a firm grip on the tool at all times.
•
Seek assistance from Pitsco Idea Shop staff with any questions.
•
Specific Router Safety
• Use only for cutting wood.
• Hold power tool by insulated gripping surfaces, because the cutter may contact its own
cord.
• DO NOT cut metal.
• Keep handles and gripping surfaces dry, clean, and free from oil and grease. This will
enable better control of the tool.
• Maintain firm grip with both hands on router to resist starting torque.
• Keep hands away from cutting area. Never reach under the workpiece for any reason.
Keep the router base firmly in contact with the workpiece when cutting
• Never run the motor unit when it is not inserted in one of the router bases.
• Keep cutting pressure constant. Do not overload motor.
• Check to see that the cord will not snag or impede the routing operation.
• Use sharp cutters. Dull cutters may cause the router to swerve or stall under pressure.
• Be sure that the motor has stopped completely before you lay the router down.
• Be sure that the router bit is clear of the workpiece before starting the motor.
• ALWAYS disconnect tool from power source before making adjustments or changing
bits.
• Keep hands clear of bit when motor is running to prevent personal injury.
• NEVER touch the bit immediately after use. It may be extremely hot.
• Provide clearance under workpiece for router bit when through-cutting.
• Tighten collet nut securely to prevent the bit from slipping.
• Never tighten collet nut without a bit.
• Do not use router bits with a diameter in excess of 1-3/8" (34.9 mm) in this tool.
• Always use cutters with a shank diameter of 1/4" (6.4 mm) which corresponds to the
size of the collet in your tool.