Infinite Peripherals Infinea BluePad Quick Start Manual

INFINEA BluePad
®
QUICK START GUIDE
BLUETOOTH PAIRING
Configuration is not required. To begin pairing,
power on the unit and do the following:
1. On iOS device go to Settings > Bluetooth
and search for the BluePad. The device is
sorted by serial number.
2. Select device to initiate pairing. Select Pair
when prompted for the Bluetooth Pairing
Request.
3. Power cycle the unit once to save the new
pairing.
Note: The BluePad can only be paired once, and
then it is no longer discoverable and must be
reset to be discoverable again. To reset:
• Turn on Infinea mPOS device and go into
SYSTEM MODE > SETTINGS > BLUETOOTH
• Scroll to MASTER RESET using up/down
arrow keys and press OK button.
ABOUT YOUR INFINEA®
FRONT PANEL
Magnetic Stripe Reader (MSR)
Smart Card Reader (SCR)
Note: Box contents and part numbers may vary based on
order configuration.
*
(WITH BLUETOOTH FIRMWARE v2.16)
Bluetooth Modes
Super Hidden (default):
• Discoverable once for initial pairing,
becomes undiscoverable after pairing.
• Additional pairing may be completed
through mPOS System Mode > Settings >
Bluetooth > Pairing.
Invisible:
• Not discoverable at all.
• To pair, use the Pairing mode in mPOS
System Mode > Settings > Bluetooth >
Pairing.
Discoverable:
• Discoverable at all times.
• May be paired at any time, as long as device
is not currently connected to a different
device.
Hidden:
• Discoverable once for initial pairing,
becomes undiscoverable after pairing.
• Additional pairing may be completed
through mPOS System Mode > Settings >
Bluetooth > Pairing or by using a command
to directly pair by MAC address.
All modes allow pairing to multiple devices.
Once the Infinea mPOS is paired to multiple iOS
devices, the last connected device is reconnected
by priority after a power cycle.
BluePad
MENU NAVIGATION
Display
NFC Label
(Contactless version only)
The following keypad buttons are used to
access and navigate through the various
screens and menu options:
BUTTON
Keypad
USING THE INFINEA BLUEPAD
* Bluetooth Option Not Standard
To Use the Smart Card Reader:
1.
2.
3.
4.
To Use the Contactless Card Reader:
1.
2.
To Use the Magnetic Stripe Reader:
1.
2.
3.
system mode
info version
info hardware
DESCRIPTION
POWER Powers on the unit.
SYSTEM Enters System Mode from
MODE Home screen.
Moves up through a list one
UP
option at a time.
Moves down through a list
DOWN
one option at a time.
OK Selects the active option
Returns to previous level or
CLEAR
exit the service mode
Position the smart card with the gold
contacts face up.
Insert the card into the ICC card reader
slot in a smooth, continuous motion until it
seats firmly.
Give the BluePad to the customer for PIN
entry.
Remove the card when the display
indicates the transaction is complete.
Place the RFID tag/card over the receiver/
transmitter as indicated by the RFID label
on the front of the BluePad unit.
Press the reading RFID card button on
the application. The data is sent from the
BluePad reader to the mobile device.
Position a magnetic card with the stripe
face down.
Insert the card into the MS card reader slot
and then quickly swipe it through.
Give the BluePad to the customer for PIN
entry.