CertainTeed NO-COAT PRO Operating Instructions

1.
DO NOT tear or
remove this area
of box!
3.
4.
Spindle Arm
Spindle
7.
CertainTeed
Operating Instructions
2.
3.
5.
Top View
Spindle Arm
Spindle Corner Pin
6.
Spindle Cap
8.
8.
TO LOAD NO-COAT PRO CORNER INTO THE NO-COAT PRO MACHINE:
1. Push in perforated section above finger hole.
2. Tear out perforated large end panel and remove.
3. Using finger holes, remove perforated panels on both sides of the box.
4. Lift box with perforated end panel facing machine, and mount over spindle.
5. Box should fit snugly against spindle arm, resting on the spindle and corner
pin (as shown in #7).
6. On opposite box side, make sure box sits on spindle and is secured in
place by spindle cap.
8. Pull end of NO-COAT PRO Corner out of box between guides.
9. Feed NO-COAT PRO Corner through open slot into feed rollers using the feed
knob. Make sure center groove in product lines up with centering roller.
Turn feed knob until product stops against inside cutter blade.
10. To remove or adjust position of NO-COAT PRO Corner, push down on feed
release lever.
Feed Rollers
Guide Pin
Feed Release Lever
Centering
Roller
Feed Knob
Guide
T
urn Feed Knob counter-
clockwise only!