CertainTeed NO-COAT PRO Operating Instructions

DO NOT tear or
remove this area
of box!
Front
Spindle Arm
Spindle
Spindle Cap
CertainTeed
Operating Instructions
Back
Spindle Arm
Top View
Spindle Corner Pin
TO LOAD NO-COAT® PRO CORNER INTO THE
NO-COAT® PRO MACHINE:
1. Push in perforated section above finger hole.
2. Tear out perforated large end panel and remove.
3. Using finger holes, remove perforated panels on
both sides of the box.
4. Lift box with perforated end panel facing machine, and
mount over spindle.
5. Box should fit snugly against spindle arm, resting on the spindle
and corner pin.
6. On opposite box side, make sure box sits on spindle and is secured
in place by spindle cap.
7. Pull end of NO-COAT PRO Corner out of box and slide under
guide pin.
8. Feed NO-COAT PRO Corner through open slot into feed rollers
using the feed knob. Make sure center groove in product lines
up with centering roller. Turn feed knob until product stops
against inside cutter blade.
9. To remove or adjust position of NO-COAT PRO Corner, push
down on feed release lever.
Feed Rollers
Guide Pin
Feed
Release
Lever
Centering
Roller
Feed Knob
Guide
T
urn Feed Knob
counter-clockwise only!