Advertisement
ASSEMBLY
Refer to Figure 2–9
1.
Apply the self-adhesive wear resistant strips to the
underside of the sled. See Figure 2.
Figure 2
Wear Resistant Strip
Underside
4
of Sled
2.
Assemble the eight slotted nylon adjustment screws into the
24" miter bar. Do not tighten, adjustment will be made later.
3.
Place the miter into slot on the underside of the sled and
attach using three 1/4"-20 x 3/4" flat head Phillips screws.
See Figure 3.
Figure 3
Miter Bar
Underside
of Sled
Miter Slot
Wear Resistant Strip
1/4"-20 x 3/4" Flat Head Phillips Screws
Slotted Nylon Adjustment Screws (8)
4.
Attach the adjustable stop to the table using two 1/4"-20 x
3/4" flat head Phillips screws. Make sure the set screw is
positioned to the outer edge of the sled and the side marked
with a "O" is facing up. See Figure 4.
Figure 4
0
Edge of Sled
1/4"-20 x 3/4" Flat Head Phillips Screws
5.
Slide three 5/16"-18 x 1" T-Bolts into the slot of the MDF
fence face and insert through the extruded fence. Secure
with 5/16" round knobs. See Figures 5 and 6.
Figure 5
5/16"-18 x 1" T-Bolts
MDF Fence Face
Figure 6
Fence Face
5/16"-18 x 1" T-Bolts
Extruded
Fence
5/16" Round Knobs
Adjustable Stop
1/4"-20 x 3/4" Flat
Head Phillips Screws
Set Screw
MDF Fence Face
Advertisement
