Extron electronics UCS FT 901 Setup Manual

UCS FT 901 and UCS FR 902 • Setup Guide
This guide provides basic instructions for an experienced technician to install and
configure the Extron UCS 900 Series. The UCS FT 901 and UCS FR 902 extend USB
signals from USB 3.x, 2.0, and 1.1 peripheral devices located up to 492 feet (150 meters)
away to a USB 3.x host computer over multimode fiber optic cable, with a SuperSpeed
data transfer rate of up to 5 Gbps. The transmitter features a USB Type-C connector.
The receiver features a built-in active two-port hub that supplies up to 5 V, 1.5 A from
each port to power attached devices.
See the UCS FT 901 and UCS FR 902 User Guide, available at www.extron.com, for more information.
NOTE:
•
This product supports USB data ONLY. DisplayPort Alt Mode and Power Delivery are NOT supported.
•
The use of a USB 2.0 hub on the UCS FR 902 is not recommended. If a hub is needed in the system, Extron
recommends the use of a USB 3.x hub. Please contact your Extron AE for more details.
Installation
ATTENTION:
Installation and service must be performed by authorized personnel only.
ATTENTION :
L'installation et l'entretien doivent être effectués uniquement par un technicien qualifié.
Mounting
The UCS FT 901 and UCS FR 902 can be rack mounted, furniture mounted, or placed on a tabletop with the provided rubber feet.
For ZipClip mounting instructions, see the UCS FT 901 and UCS FR 902 User Guide at
Connecting Cables
WARNING:
Fiber optic connectors emit continuous invisible light, which may be harmful to the eyes; use with caution. Do
not look into the fiber optic cable connectors or into the fiber optic cables themselves. Plug the attached dust caps into the
optical transceivers when the fiber cable is unplugged.
ADVERTISSEMENT :
pour les yeux ; à utiliser avec précaution. Ne pas fixer directement les connecteurs optiques ou les câbles fibre optique.
Branchez les protections contre la poussière dans l'ensemble émetteur/récepteur lorsque le câble fibre optique est
débranché.
The illustration below shows connections for the UCS FT 901 and UCS FR 902.
Laptop
USB
Transmitter
SS 5G 4 4 4
Tx
POWER
12V
0.1A MAX
USB-C
HOST OUTPUT
Compatible with USB 3.x
3 3 3
host ports ONLY
Ground all
Ground
G
+12 VDC input
Les connecteurs de fibre optique émettent une lumière invisible continue, qui peut être dangereuse
Multimode Fiber Optic Cable
5 5 5
Rx
External Power Supply
(12 VDC, 0.5 A max.)
1 1 1
Devices
www.extron.com.
USB Camera
USB
Receiver
POWER POWER
6 6 6
1.5 A
POWER
12V 12V
12V
1.0A MAX 1.0A MAX
1 2
1.6A MAX
DEVICES
Compatible with USB 3.x, 2.0, 1.x
3 3 3
peripheral devices
Ground all
Devices
G Ground
+12 VDC input
5 5 5
Tx Rx
1 1
2 2 4 4
INPUT
External Power Supply
(12 VDC, 2.0 A max.)
2 2 2
1